TOC Analyzer for Waste Water Treatment Plants Effluent
LAR's QuickTOCeffluent is the ultimate online TOC analyzer for the determination of total organic carbon (TOC) for waste water treatment plants effluents.
QuickTOCeffluent
Features & Benefits
- Measurement range: 0.1 - 200 mg/l
- Response time: 2-3 min
- TC, TOC monitoring
- Easy calibration and validation (QuickCalibration)
- Highest combustion temperature (1,200°C) on the market
- Catalyst-free technique
- No filtration necessary at the effluent
- No memory effects
- Low operational and maintenance costs
- According to DIN EN 1484:1997-08, ISO 8245:1999-03 and EPA 415.1
LAR's total organic carbon analyzer is suitable for a variety of applications and types of water:
- Municipal WWTP outlet
- Industrial WWTP outlet
- Process water
- Detailed application overview
Using analyzer options, the measurement system is adaptable for every measurement challenge.
- Combination with TNb detection
- Ambient Air Preparation Unit
- CO2-Remover
For safe operation in hazardous areas, there are different protection housings available:
- IP54 (Standard)
- NEMA 4X
- ATEX Zone I
- ATEX Zone II
- IECEx
Warm, warmer, hot. Tracking organic load at 1,200°C.
The catalyst-free ceramic oven is the centrepiece of the QuickTOCeffluent. At 1,200°C, it reliably dissolves all carbon bonds and thus enables a complete analysis of samples. Despite the high temperatures used, absolute safety is guaranteed in all settings. To this end, the QuickTOCeffluent can be delivered with a number of different housings, depending on the intended location, enabling the analyzer itself to be safely located in highly corrosive environments as well as in Ex-Zones.
Catalysts. For our analysers simply not necessary.
Lower temperatures at 680-1,000°C need catalysts to provide satisfying oxidation power. Even then complex compounds often are not determined. Because of the high temperature used the QuickTOCeffluent does not need any catalysts.
The QuickTOCeffluent. Ultra quick measurements and maintenance.
The TRUE TOC measurement takes place in less than 3 minutes. This speed guarantees that very short peaks can be determined very well during a daily cycle. The analyser's availability is over 98%.
The loop injection. For clean sample dosage.
The sample is injected into the furnace via an injection loop. Moreover, this loop defines simultaneously the sample volume. The loop system ensures that the sample is 100% sealed off from ambient air. Even the smallest impurities are excluded and the sample can be analyzed correctly in the lowest ppb range.
