COD Analyzer QuickCODultra for the Rough Stuff

COD Analyzer for the Rough Stuff

LAR’s COD analyzer QuickCODultra is the most reliable measurement system for the roughest waste water applications. Due to an unrivaled injection and oxidation technique, the QuickCODultra easily handles sticky, fatty, salty, and high-particle samples unlike other COD analyzers without the need of any hazardous chemicals.

Features and Benefits

Measurement range: 10 – 150 mg/l, 100 – 2,000 mg/l, 500 – 5,000 mg/l, 1,000 – 8,000 mg/l, 20,000 – 250,000 mg/l, further options available
Response time: 1 – 2 minutes
Measures the real oxygen demand
Highest combustion temperature (1,200°C) available on the market
Catalyst-free technique
Reliable measurement without reagents
No filtration necessary
No memory effects
Very low maintenance and operational costs

Applications

LAR’s chemical oxygen demand analyzer is suitable for a variety of applications and types of water:

Water Influent
Water Effluent
Discharge Control
Industrial Waste Water
De-Icing Water
Process Water
High Salt Concentrations

Options

Using analyzer options, the measurement system is adaptable for every measurement challenge.

FlowSampler
Multi-stream measurement for up to 6 sample streams
Combination with TOC and TNb detection

Housings

For safe operation in hazardous areas, there are different protection housings available:

IP54 (Standard)
NEMA 4X
ATEX Zone I
ATEX Zone II
IECEx

Headline

Product Broschure

Online COD for every kind of water. Especially for the rough stuff.

LAR’s QuickCOD_ultra is the ultimate online COD analyzer for the determination of chemical oxygen demand (COD) suitable even for the most difficult waste water applications.

Exact Analysis. Clean, fast and accurate.

Exact Analysis. Clean, fast and accurate. In contrast to the common standard methods, which are time consuming and require dangerous reagents, the QuickCOD_ultra uses the combustion method. It is fast, using the original idea considering the oxygen required for the oxidation of the organic components contained in the water. This method goes without any use of dangerous and etching substances so that a high operational safety is ensured. Another advantage of this method is that the measurement results are taken from the complete digestion and free from chloride interference.

The real COD. Even with changing sample matrixes.

The entire raw waste water sample including all particles is directly injected into a furnace via the unique injection system. With our ULTRA high temperature method oxygen is used to digest all components. This demand is detected by a special oxygen detector so that the analyser truely measures the real oxygen demand. Even with applications with changing sample compositions the QuickCOD_ultra reliably determines the COD.