TOC Analyzer for the Pharmaceutical Industry

LAR's QuickTOCpharma is the ultimate online TOC analyzer for the determination of total organic carbon (TOC) for ultra pure water and pharmaceutical water providing optimal process control.


Features & Benefits

  • Measurement range: 0 - 2,000 µg/l
  • Response time: < 3 min
  • TOC monitoring
  • Easy calibration and validation (QuickCalibration)
  • Highest combustion temperature (1,200°C) on the market
  • Catalyst-free technique
  • Closed system to prevent contaminations
  • Software according to 21 CFR Chapter 11
  • Single and dual stream operation
  • No memory effects
  • Low operational cost
  • According to USP Chapter 643 and EP 2.2.44
TOC Analyser QuickTOCpharma

LAR's total organic carbon analyzer is suitable for almost every pharmaceutical water challenge:

Using analyzer options, the measurement system is adaptable for every measurement challenge.

  • FlowSampler
  • Multi-stream measurement for up to 6 sample streams
  • Combination with COD and TNb detection

For safe operation in hazardous areas, there are different protection housings available:

  • IP54 (Standard)
  • NEMA 4X
  • ATEX Zone I
  • ATEX Zone II
  • IECEx

IECEx Certificate of Conformity

Warm, warmer, hot. Tracking organic load at 1,200°C.

The catalyst-free ceramic oven is the centrepiece of the QuickTOCpharma. At 1,200°C, it reliably dissolves all carbon bonds and thus enables a complete analysis of samples. Despite the high temperatures used, absolute safety is guaranteed in all settings. To this end, the QuickTOCpharma can be delivered with a number of different housings, depending on the intended location, enabling the analyser itself to be safely located in highly corrosive environments as well as in Ex-Zones.

Software. According to 21 CFR Chapter 11.

The software conforming to FDA (CFR 21 Chapter 11) permits inter alia data storage and an electronic signature in accordance with the requirements. The analysis system is fully controlled by the software and combines the high standards for the measurement of pharmaceutical waters, especially for HPW and WFI in one.

The QuickTOCpharma. Ultra quick measurements and maintenance.

The TRUE TOC measurement takes place in less than 3 minutes. The TRUE TC you even get within a minute. The TC is particulary advantageous if a high proportion of the TIC is present, which is hereby considered.

This speed guarantees that very short peaks can be determined very well during a daily cycle. The analyser's availability is over 98%. Even when used in high salt applications its weekly service is about 30 minutes.

Calibration and validation. Ready at any time.

LAR offers with the patented calibration and validation technique QuickCalibration giving the opportunity to check the analyser automatically and remotely at any time. In contrast to the use of liquid standards, that must be produced or purchased, contributing to expense, our unique method uses a defined gas which remains stable for a long time and is ideal for automatic calibrations without personnel on site. Therefore, it can be quickly checked as to whether your analyser is measuring correctly.

The loop injection. For clean sample dosage.

The sample is injected into the furnace via an injection loop. Moreover, this loop defines simultaneously the sample volume. The loop system ensures that the sample is 100% sealed off from ambient air. Even the smallest impurities are excluded and the sample can be analyzed correctly in the lowest ppb range.

Contamination of test equipment in the loop system is technically impossible.

The TOC is one of the most important composite parameters in the assessment of the organic pollution of water.

Need further information?

Contact us right here

Related news for QuickTOCpharma

Total Organic Carbon analysers are commonly used to measure the level of organic contamination in water. Online TOC analysers installed in refineries and petrochemical plants are located right in the middle of the process facilities.